Technical Specifications for GA902

Noise Activated Warning Sign

OPERATION
The microphone receives noise and passes it to the built in sound level meter where it is compared to the pre-set trigger level which if exceeded, switches on the twin fluorescent lamps to illuminate the warning sign. Once the noise in the area falls below the threshold for more than a pre-set time the lamps are extinguished.
 
SETTING THE ACTIVATED NOISE LEVEL
The unit is factory calibrated to 85dBA and a series of internal switches enables the user to select the desired trigger level in steps of 2.5dB.
 
ORDERING INFORMATION
GA902 Noise Activated Warning Sign (specify 110v or 240v)
GB001 Remote Beacon. This can be placed remotely to improve visibility (specify 110v or 240v)
GB0003 Mini-Beacon. This is attached to the underside of the GA902 (specify 110v or 240v) Note: Beacons are normally supplied in Orange but are also available in Blue or Red.
 
MEASURING RANGE
75dB to 112.5dB steps switch selectable 5dB variable calibration control (factory set).
 
TRIP TIME
User adjustable 5 to 30 seconds.
 
CONTROLS
Push to test button
Mains power 'on' indicator
 
DETECTOR
Characteristic: Averaging
 
FREQUENCY WEIGHTING
'A' in accordance with IEC651 Type 2
 
TIME RESPONSE
Slow response (1000mS)
 
MICROPHONE
Built in Castle 1/2" electret
 
OUTPUTS
Switched AC power feed for external beacon
Change-over relay contact sets
 
POWER
200v to 240v AC, 50Hz/60Hz
110v to 120v AC, 50Hz/60Hz
(240v version supplied as standard unless otherwise stated at time of order)
 
ILLUMINATION
Two 8w, 12" Fluorescent tubes
 
BEACONS
The GA902SS is available with an optional Remote Beacon, specify GB001
 
DIMENSIONS
Front: 500 x 240mm
Back: 300 x 240mm
Width: 140mm
 
FEATURES:
SELF CONTAINED UNIT
STAINLESS STEEL CASING
WATERPROOF SEALS
BUILT IN MICROPHONE
EASILY INSTALLED
MAINS POWERED
FULLY AUTOMATIC
IP RATED
BLANK WHEN OFF
AVAILABLE WITH OPTIONAL REMOTE BEACON